Click image to view full size image
| Items | DH260 | DH300 | DH400 | DH500 | DH1000 | |||
| Center hight mm | 260 | 300 | 400 | 500 | 1000 | |||
| Swivel angle of spindle from horizontal to upward | ≤95° | |||||||
| Horizontal position(downward) | ≤5° | |||||||
| Rotating angle of spindle for one complete revolution of dividing handle | 9° | |||||||
| Min. reading of vernier | 10" | |||||||
| Worm gear ratio | 1:40 | |||||||
| Taper of spindle bore | MT6 | MT6 | MT6 | MT5 | MT5 | |||
| Width of locating key mm | 18/20 | 18/20 | 18/20 | 22 | 22 | |||
| Dia.of short taper of spindle nose for mounting flange mm | Φ82.563 | Φ82.563 | Φ82.563 | Φ106.375 | Φ212.375 | |||
| Numbers of hole in dividing plate | 1st plate | 24,25,28,30,34,37,38,39,41,42,43 | ||||||
| 2nd plate | 46,47,49,51,53,54,57,58,59,62,66 | |||||||
| Individual indexing error of the spindle for one complete revolution of dividing handle |
80" | 80" | 80" | 500 | 1000 | |||
| Cumulate error at any 1/4 periphery of spindle | ±70" | ±70" | ±70" | ±1" | ||||
| Max. bearing Kg | 380 | 380 | 380 | 100 | 500 | |||
1.Tailstock 2.Dividing plate 3.Flange 4.3-jaw chuck